RL R030-01 Manual Del Usuario página 8

If a leak or spill occurs on the surface of device, unplug the air cooler and let it dry for
24 hours Then use as normal.
Do not place in direct sunlight for extended periods of time
If the air cooler is not going to be used for extended periods of time, first empty the
water tank, turn the unit on, and set to highest fan speed for at least 4 hours. This will
dry out the filter and inside of your unit
Only use the original power adapter and cord supplied in package
Do not touch the power supply or power cord with wet hands
Unplug the air cooler when cleaning, removing/replacing filter, or moving the device
For best results, place the air cooler on a higher surface like a table or countertop
Do not place the air cooler near a heater or any electrical equipment
Do not place the device in passageways or high traffic areas where there is a
possibility of tripping or knocking it over
Do not allow any foreign objects inside the air cooler.
Do not place items on top of the air cooler
Do not block the front and back grilles of the device
Do not turn the device upside down
Do not submerge the air cooler under water or other liquids
Do not place the air cooler near open flames or fire sources
Tips
Place the air cooler on a raised surface such as a table, desk or counter top. This is
the best way to cool your personal area faster
Let the filter absorb water for at least 3 minutes after filling tank and before use.
Doing so will get you the coolest air quicker
Try to stay within a few feet of the air cooler. You'll feel the most benefit when sitting
directly in front of it
The air cooler will run for approximately 8 hours on a single fill on Low fan speed.
Even if the water tank is empty, the filter is still damp and the air cooler is still cooling
Setup
1. Place the air cooler on a flat surface. (See Fig 1)
2. Open the water tank door and fill with water (See Fig 2). We recommend a
pitcher or measuring cup
3. Plug the USB power adapter into an outlet. Then, insert the larger USB end of
the cable into the adapter and the smaller end into the power port on the back
of the air cooler. (See Fig 3)
NOTE: You can plug the larger USB end into a computer to power it as well
Usage
1. Press the Power button to power on the air cooler
(See Fig 4)
2. Set the fan speed by pressing the button. You can choose from low, medium,
and high mode. The indicator lights next to the button show you which speed
the air cooler is currently running at (See Fig 5)
3. Choose your light color by pressing button
You can choose between solid colors or a color-cycle
mode (See Fig 6)
Art.-Nr.: R030-01