Carpoint 02.600.61 Manual De Usuario página 5

In total max. 4 transmitters can be added to the alarm system. Put the car key into the key lock and switch
to ACC On. Press the reset switch 5 seconds. The siren will chirp 5 sounds and the LED indication will be on.
• Within 10 seconds, press any button on the first transmitter until the siren chirps 2 times.
• Within 10 seconds, press any button on the second transmitter until the siren chirps 3 times.
• Within 10 seconds, press any button on the third transmitter until the siren chirps 4 times.
• Within 10 seconds, press any button on the fourth transmitter until the siren chirps 5 times.
The LED indication will go off.
attentIon: tHe addIng of transmItters wIll stop after no aCtIons wItHIn
10 se-Conds, key Is taken out of key loCk or wHen four transmItters are
added. eVery tIme you add a transmItter, you HaVe to add all your trans-
mItters.
MAIN UNITS
Brain unit:
Shock sensor:
Wire harness:
Siren:
Reset switch:
INSTALLATION INSTRUCTION CAR ALARM
• Brain unit: The brain unit is usually placed under the instrumental panel or another disguised place. Place
the brain unit where all wires can be connected. The brain unit can be attached with Velcro tape with a sticky
back.
• LED indicator: Place the LED indicator on the dashboard where it can be seen from outside the car and from
the driver seat. Connect the indicator to the brain unit.
• Siren: Place the siren on a non accessible place, e.g. under the hood. Place the siren with the opening facing
down because of water. Use one of the screws for the mass connection. Connect the siren to the brain unit.
• Reset switch: Place the reset switch on a non visible position but accessible from the driver seat. Connect the
reset switch to the brain unit.
• Shock sensor: Place the shock sensor on an accessible place because of adjusting its sensitivity. Place the sen-
sor as tightly as possible on a solid base of the car so vibrations can be picked up by the sensor. Connect the
sensor to the brain unit. The sensitivity was set by our factory. It is suggested not to change it if not necessary.
• Shock sensor adjustment: There is a LED in the shock sensor that will flash when the sensor is triggered. You
can adjust the sensitivity with a screwdriver. Turn to the right (H) to make the sensitivity higher. Turn to the
left (L) to make the sensitivity lower.
• Microwave sensor (optional): Place behind a plastic panel or behind lining but keep it accessible because of
adjusting. Do not place the microwave sensor on metal. Connect the sensor to the brain unit.
CONNECTING WIRES AND PLUGS
1. Determine the position of the brain unit, but don't attach it yet.
1
1
1
1
1
Transmitter:
LED indicator:
Relay:
User manual:
2
1
1
1