Uline H-2827 Manual Del Usuario

π
FIXED DOUBLE FOLDING SECURITY GATE
TOOLS NEEDED
3/4" Masonry Drill Bit
1/4" Masonry or Wood Drill Bit
1. Before installing, decide on gate placement. "L" brackets
that form top hinge allow gate placement in the recess
of door frame. Installation can also be made outside or
inside of wall next to door or opening frame. (See Figure 1)
Either side of gate can be toward the outside of building. A
label on the operating side (the side with the center drop
pins) indicates RHT (right) or LFT (left) of a person facing the
operating side.
2. Have a helper extend the gate and stand it upright where it
will be mounted. Drill 3/4" diameter x 3" deep hole, 1⁄" from
wall into the floor for gate pin to set into. Place a bearing
washer over floor hole and set bottom gate pin into floor
mount hole. (See Figure 2)
Figure 1
CAUTION! Check to confirm gate will swing away
from opening when not in use. This will provide a
clear opening for normal traffic.
3. Extend gate and hang "L" bracket on top of gate to verify
where it will be mounted. To release tension you may lift the
wheel 1/2"-3/4" off the floor. Mark and drill pilot holes into
door frame or wall. It may be easier to drill pilot holes if you
remove the gate from its floor mount. Place bearing washer
and bottom gate pin back into floor mount. Slip "L" bracket
over top of gate and bolt (not included.) (See Figure 3)
• Wood door frames or walls: 5/16" x 2" lag bolts.
• Steel door frames or walls: Drill and tap for
5/16" x 2" lag bolts.
• Brick or concrete frames or walls: 5/16" x 2"
Lag bolts set into 3/8" holes with lead anchors.
PAGE 1 OF 3
PARTS NEEDED
5/16 x 2" Long Lag Bolt
Masonry Door Frame or Wall Installations
(Wall Installations may require lead anchors)
INSTALLATION
4. Raise center drop pin and use attached notch to keep in
place; this prevents damage to floor surface.
(See Figure 4) Extend and retract gate to its stops to work
out stiffness. Repeat steps 2-3 for other half of gate.
Figure 2
5. With center drop pin raised, extend both halves of gates
together to center of opening, mark floor for center
drop pin hole and drill a 3/4" diameter x 3" deep hole.
Lower center drop pin (Note: some larger gates have an
additional pin in the center of each web, mark and drill
these last.) Open gates slowly at first to avoid warping.
(See Figure 5)
Pour le français, consulter la page 3.
1-800-295-5510
uline.com
PARTS INCLUDED
2" Standard "L" Bracket x 2
Bearing Washer x 2
CAUTION! Notice that center drop pin at this stage
hits the other half of gate or rests on floor. Do not
cut off drop pin.
Para Español, vea página 2.
Figure 3
Figure 4
Figure 5
0621 IH-2827