Safety And General Information; Fcc Statement - Anycom PAROS-10 Manual Del Usuario

www.anycom.com

14. Safety and General Information

Please read this guidebook carefully and follow the instruction. To avoid any damage or malfunction of the unit, do not drop it from high
place. Keep away unit from humidity, water and any other liquid. And if the unit is exposed by water, moisture and other liquid directly, then
do not operate it normally to avoid any electrical shock, explosion and damage of the unit. Do not place or keep the unit near the heat
sources such as direct sun light, radiators, stoves or other apparatus which produce heat. It may cause explosion, degrade of performance
and reduce battery life. Do not modify, repair & disassemble unit at discretion (especially battery: it may cause an explosion) Do not place
the heavy objects on the unit. Use only supplied and approved charger. Replacement or service must be done at a qualified service center
or manufacturer. Unplug this unit when unused for long period of time or during lightening storms.
CAUTIONS: ELECTRIC SHOCK HAZARD
The battery used in this device may present a risk of fire or chemical burn if mis-treated.

15. FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received , including interference that may cause undesired operation.
Note: The manufacturer is not responsible for ANY interference, for example RADIO or TV interference, caused by unauthorized modifications to
this equipment. Such modifications could void the user's authority to operate the equipment.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
1.
Reorient or relocate the receiving antenna.
2.
Increase the separation between the equipment and receiver.
3.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for
help.
PAROS-10
Page 7
English