Tabla de contenido
Publicidad
Identify pole sections.
3.
While maintaining alignment, bounce middle pole section (5) into top section (4)
4.
using a wood scrap as shown until the top pole no longer moves toward the pole
identification sticker on the middle pole.
IMPORTANT!
Align dimple of top pole section (4)
into trough of middle pole section (5)
as shown.
5"
ID# M6611043
4
ID
STICKER
1-1/2"
DIMPLE
HOLE
01/07
5
Identification Sticker
5
4
14
6
CAUTION!
THE IDENTIFICATION STICKER
IS LOCATED 5" FROM THE END
OF THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE
POLE SECTIONS SHOULD HAVE
A 3-1/2" MINIMUM OVERLAP,
LEAVING 1-1/2" BETWEEN THE
OVERLAPPING POLE AND THE
IDENTIFICATION STICKER.
WOOD SCRAP
(NOT SUPPLIED)
Publicidad
Tabla de contenido
