Installing The Battery - BAUKER CGT300JN Manual De Instrucciones

Adjusting the shaft length
Loosen the bottom of the center collar (Fig. 7, Page 69). This will allow the lower part of
the shaft to be extended or retracted. When the shaft is at a comfortable length,
retighten the collar.
The shaft can be rotated to 0 ° or 180 ° position for trimming and edging operations.
Pull the upper part of the center collar (Fig. 8, Page 69). This will allow the engine to be
rotated at 0 ° or 180 °.
NOTE: The spool will only lock in the 0 ° or 180 ° position.
Rotating the cutting line spool
The cutting line spool can be rotated to 0 ° or 90 ° position for trimming and edging
operations.
Press the trimmer adjustment button (Fig. 9, Page 69) and the cutting line spool will
spring around 90 °. Make sure it is locked into place. To move the cutting line spool
back, simply press the string trimmer adjustment button again and rotate back to its
original position.
Cutting line extension
To extend the line, press the cutting line extension button on the spool (Fig. 10, Page 70).
Warning! To prevent accidental starting, which could cause serious personal injury,
always remove the battery pack from the product when extending the cutting line.
The cutting line can be set at two lengths (250 mm e 300 mm). To adjust the length of
the cutting line, push the adjustment knob of cutting line and rotate 180 ° (Fig. 11, Page
70).
71
Rotating the shaft
Adjusting the cutting line blade
Warning! Always remove battery pack from your tool when you are assembling parts,
making adjustments, cleaning, carrying, transporting or when not in use. Removing
battery pack will prevent accidental starting that could cause serious personal injury.

Installing the battery

NOTE: To avoid serious personal injury, always remove the battery pack and keep hands
away from the lock-unlock button when moving or transporting the tool.
Slide the battery pack into the tool base (Fig. 12, Page 70). Note the battery has raised
ribs, which allows it to fit into the charger only one way. Make sure that the battery
snaps into place and that it is secured to the tool before use. Improper installation of the
battery pack can cause damage to internal components.
Removing the battery pack
Press the battery release button on the top of the battery (Fig. 13, Page 70). While
holding down the battery release button, remove the battery from the base.
Assembly Instructions
72