Lenco MC-150 Manual De Usuario página 9

6. To select another channel (Example: 5A-13F), press the PREVIOUS
confirm.
7. To quit manual scan, press the MENU button on the remote control.
Tuning
Press the TUNE or TUNE
station in few seconds.
Storing DAB Presets
You can save up to 20 DAB stations.
1. Tune to the station you wish to store.
2. Press and hold the MEMORY button to access the menu control. Flashing "PROG" is displayed
3. Press the TUNE or TUNE
Stored DAB Presets
Press the CH- or CH+ button directly tune to the preset channel.
Displaying DAB Station Information
There are several types of information as listed below. To change the display information, press the INFO button repeatedly.
1. Radio Text scrolling
Comprises music titles or programme details provided by the broadcaster.
2. Signal Bar
Reception signal level.
the wire antenna position.
3. Program Type (PTY)
Type of program provided by the Radio station.
4. Multiplex Name
Displays name of multiplex to which the current station belongs.
5. Frequency
Current channel frequency.
6. Signal Error Rate
It shows the error received. The larger this value the more errors are received. To improve the reception adjust position of the
wire antenna.
7. Audio Bit Rate
This is the current channel audio
OTHER DAB MENU OPERATIONS
Press the MENU button on the remote control to access the menu control. Then press the PREVIOUS
different options as described below.
Dynamic Range Control (DRC)
DRC can make quieter sounds easier to hear when the unit is used in a noisy environment. The DRC level of a broadcast is set by the
radio station and transmitted with the service. Changing the DRC value on your unit enables you to apply a scaling factor to this level.
There are three levels of compression:
DRC high:
DRC low:
DRC off:
1. Press the MENU button on the remote control to access the menu control.
2. Press the PREVIOUS
3. Press the PREVIOUS
4. Press the MENU button on the remote control to exit the menu control.
Note:
- Not all DAB stations are able to use DRC function. If the radio station does not support DRC then the DRC setting in the unit will
have no effect.
- After you have adjusted the DRC level the sound may be louder.
Prune
This function removes inactive stations.
1. Press MENU button on the remote control to access the menu control.
2. Press the PREVIOUS
3. Press the PREVIOUS
button to display the information of the next station. Then press the ENTER button to tune to this
button to a preset number that you want to store. Then press the ENTER button to save.
The more the star mark is displayed, the stronger the signal is received. To improve the reception adjust
bit rate.
Maximum compression as sent with the transmitted service
Set to 1/2 that of the sent transmitted service
No compression
or NEXT button until "DRC" is displayed and then press the ENTER button.
or NEXT button to select the DRC value and then press the ENTER to confirm.
or NEXT button until "PRUNE" is displayed and then press the ENTER button.
or NEXT button to select "PRUNE Y" and then press the ENTER button to prune the unit.
or NEXT button and then press the ENTER button to
9
or NEXT button for