Maintenance And Storage - IVT MTS-255-RC Manual De Instrucciones

cutting head to the desired bevel angle and tighten the
bevel locking lever (13).
∙
Place the workpiece on the miter table (11) with one
edge securely against the rear fence (8). If the workpiece
is warped, ensure the convex side is against the rear
fence (8). Use a clamp to secure your workpiece.
3. To make a compound miter cut [F8]:
∙ Move the miter table (11) to the left or the right to
set the desired angle. Use the miter angle indicator (10)
as a guide.
∙ Retighten the miter locking knob (19) once the
machine is set at the required angle.
∙
Loosen the bevel locking lever (13) and move the
cutting head to the desired bevel angle as shown on the
bevel angle indicator (20).
4. Turn on the machine, wait for the saw blade (6) to
reach full speed and then lower the cutting head so the
saw blade (6) starts cutting the workpiece.
5. Release the On / Off switch (2) when the cutting is
complete and allow the saw blade (6) to stop rotating
before raising the cutting head.
Replacing the saw blade (6)
CAUTION! Always be sure that the tool
is switched off and unplugged before
checking or adjusting functions on
the tool.
WARNING! Never use a blade that is
too thick to allow outer blade washer
to engage with the spindle. Larger
blades will come in contact with the
blade guards, while thicker blades will
prevent the blade bolt from securing
the blade on the spindle.
WARNING! To ensure the correct
blade rotation always install the
saw blade (6) with the blade teeth
pointing downwards. See the arrow (if
present).

MAINTENANCE AND STORAGE

Before any work on the device itself,
pull the mains plug.
∙ Always keep the tool and the ventilation slots (if
present) cleaned. Regular cleaning and maintenance of
the appliance will ensure efficiency and prolong the life
of your tool.
∙
If the tool should fail despite the rigorous
manufacturing and testing procedures, the repair should
be carried out by an authorized IVT customer service.
∙
Keep all nuts, bolts, and screws tight, to be sure the
tool is in safe working condition.
∙
Replace worn or damaged parts for safety.
∙
Use only original spare parts. Parts not produced
by manufacturer may cause poor fit and possible injury.
∙
Store the tool in a dry room out of reach of kids and
away from any flammable material.
∙ Never wet the device or spray water on it!
Cleaning
∙
To avoid accidents always disconnect the tool from
the power supply before cleaning or performing any
maintenance. The tool may be cleaned most effectively
with compressed dry air. Always wear safety glasses
when cleaning tools with compressed air.
∙
For safe and proper working, ventilation openings
and switch levers must be kept clean and free of foreign
matter. Do not attempt to clean by inserting pointed
objects through openings.
∙ Certain cleaning agents and solvents damage plastic
parts. Some of these are: gasoline, carbon tetrachloride,
chlorinated cleaning solvents, ammonia and household
detergents that contain ammonia. If the machine should
fail despite the rigorous manufacturing and testing
procedures, repair should be carried out by an authorized
customer service station or service center for the tool.
Carbon brushes
∙ The brushes and commutator in your tool have
been engineered for many hours of dependable service.
To maintain peak efficiency of the motor, we recommend
to examine the brushes every two to six months.
∙ Only genuine replacement brushes specially
designed for your tool should be used.
∙
When the resin insulating tip inside the carbon
brush is exposed to contact the commutator, it will
automatically shut off the motor. When this occurs, both
carbon brushes should be replaced. Keep the carbon
brushes clean and free to slip in the holders.
∙
Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
11
Instruction manual
EN