Safety Guidelines - Definitions; Important Safety Instructions; General Safety Warnings And Instructions - Black+Decker PPRH5B Manual De Instrucciones

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not approved by the party responsible for compliance could void user's authority to operate the equipment.
SAFETY GUIDELINES / DEFINITIONS
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious
injury.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious
injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate
injury.
CAUTION: Used without the safety alert symbol indicates potentially hazardous situation which, if not avoided,
may result in property damage.
RISK OF UNSAFE OPERATION. When using tools or equipment, basic safety precautions should always be
followed to reduce the risk of personal injury. Improper operation, maintenance or modification of tools or
equipment could result in serious injury and property damage. There are certain applications for which tools
and equipment are designed. Manufacturer strongly recommends that this product NOT be modified and/or
used for any application other than for which it was designed. Read and understand all warnings and operating
instructions before using any tool or equipment.

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS
WARNING: Read all instructions before operating jump-starter. Failure to follow all instructions
listed below may result in electric shock, fire and/or serious injury.

GENERAL SAFETY WARNINGS AND INSTRUCTIONS

• This unit was designed for household use only.
• Avoid dangerous environments. Don't use appliances in damp or wet locations. Don't use appliances in the
rain.
• Keep children away. All visitors should be kept at a distance from work area.
• Dress properly. Do not wear loose clothing or jewelry. They can be caught in moving parts. Rubber gloves
and substantial, non-skid footwear are recommended when working outdoors. Wear protective hair covering to
contain long hair.
• Store idle appliance indoors. When not in use, appliances should be stored indoors in dry, and high or
locked-up place – out of reach of children.
• Don't abuse cord. Never carry appliance by cord or yank it to disconnect from receptacle. Keep cord from
heat, oil, and sharp edges.
• Disconnect appliances. Disconnect the appliance from the power supply when not in use, before servicing,
and when changing accessories.
• Ground fault circuit interrupter (GFCI) PROTECTION should be provided on the circuits or outlets to be
used. Receptacles are available having built in GFCI protection and may be used for this measure of safety.
• Use of accessories and attachments. The use of any accessory or attachment not recommended for use
with this appliance could be hazardous. Refer to the accessory section of this manual for further details.
PPRH5B_ManualENSP_082018.indd 2-3
2
• Stay alert. Use common sense. Do not operate appliance when you are tired or impaired.
• Check for damaged parts. Any part that is damaged should be replaced by the manufacturer
before further use. Do not use tool if switch does not turn it on and off. Contact the manufacturer at (877)
571-2391 for more information.
• Do not operate this appliance near flammable liquids or in gaseous or explosive atmospheres. Motors in these
tools normally spark, and the sparks might ignite fumes.
• Never submerge this unit in water; do not expose it to rain, snow or use when wet.
• To reduce risk of electric shock, disconnect the unit from any power source before attempting maintenance
or cleaning. Turning off controls without disconnecting will not reduce this risk.
• This equipment employs parts (switches, relays, etc.) That produce arcs or sparks. Therefore, if used
in a garage or enclosed area, the unit must be placed not less than 18 inches above the floor.
• Do not use this unit to operate appliances that need more than 5 amps to operate from the 12 volt dc
accessory outlet.
• Do not insert foreign objects into the usb port, the 12 volt dc accessory outlet or the 120 volt ac outlet.
SPECIFIC SAFETY INSTRUCTIONS FOR CHARGING THIS UNIT
• IMPORTANT: This unit is delivered in a partially charged state. Fully charge unit with a household extension
cord (not supplied) for a full 40 hours before using for the first time. You cannot overcharge the unit using the
AC charging method.
• All ON/OFF switches should be in the OFF position when the unit is charging or not in use. Make sure all
switches are in the OFF position before connection to a power source or load.
Extension cords:
WARNING: Use of improper extension cord could result in a risk of fire and electric shock. When using an
extension cord, make sure that the pins of the extension cord are the same number, size and shape as those in
the charger; and be sure to use one heavy enough to carry the current your product will draw. An undersized
cord will cause a drop in line voltage resulting in loss of power and overheating. The following table shows the
correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier
gage. The smaller the gage number, the heavier the cord.
MINIMUM GAGE FOR CORD SETS
Volts
120V 0-25
(0-7.6m)
240V 0-50
(0-15.2m)
Ampere Rating
0'-25'
More Not more
Than Than
0 - 6 18
6 - 10 18
10 - 12 16
12 - 16 14
When an extension cord is used, make sure that:
a) the pins of extension cord are the same number, size and shape as those in the charger,
b) the extension cord is properly wired and in good electrical condition,
c) the wire size is large enough for the AC rating of the charger.
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: Pull by connector rather than
cord when disconnecting the extension cord from the unit; and by the plug when disconnecting the extension
cord from an AC outlet.
CAUTION: TO REDUCE THE RISK OF PROPERTY DAMAGE WHEN CHARGING USING THE 12 VOLT
DC METHOD:
• Recharge using this method only when necessary. Frequent use of the 12 Volt DC charging method may
shorten battery life.
• DO NOT EXCEED 6 HOURS CHARGING TIME USING THIS METHOD.
Total Length of Cord in Feet
26-50 51-100 101-150
(7.6-15.2m) (15.2-30.4m) (30.4-45.7m)
51-100 101-200 201-300
(15.2-30.4m) (30.4-60.9m) (60.9-91.4m)
Extension Cord Length
26'-50' 51 '-100 ' 101' -150 '
American Wire Gage (AWG)
16 16 14
16 14 12
16 14 12
12 Not Recommended
3
8/20/2018 6:10:11 PM