start-up, which interrupts power supply to the pump, in case of overcharge.
There are thermal safety fuses, which interrupt the power supply in case of boiler
or dispenser overheating.
2.8.1 Further significant indications / Safety indications
No technical modifications are allowed in this appliance. The manufacturer is not
responsible for any possible damages resulting due to modifications. The same
applies in case that the appliance is used for any other purpose except the one
anticipated, in case of fault or improper use.
The water inside the dishwasher is not potable.
Use, maintenance and repair of dishwasher should be performed only by persons
familiar with these works and informed for any possible risks.
2.8.2 Daily works
• Turn off the operation switch of the appliance (No.1- Page 3).
• Turn off the main switch / fuses.
• Turn off water supply faucet.
• Empty the washing dispenser removing the overflow pipe after turning off the
switch ON-OFF (No.1- Page 3) to avoid overcharging the tank and causing
damage to the dishwasher.
• If the dishwasher is equiped with draining pump, follow the above mentioned
steps and then press the start button once in order to start the automatically 2
minutes drainning program. (ATT: during the drainning program the door must
remain closed.)
2.9 Maintenance / Care / Repair
The perfect operation and safe use may be ensured only through the correct use
of the appliance, as well as the compliance with the operation instructions, the
corresponding specifications and the care and cleaning indications.
This applies both for the compliance of the provisions of law on appliance safety
(GSG) and the existing specifications of ZH 1 and VBG on accident prevention.
www.info@saro.de
32