Operation; Start And Stop; Operating - Chicago Pneumatic CP 2190 Instrucciones De Seguridad Y De Funcionamiento

CP 2190
1. Remove the oil plug (A) and fill the integrated
oil reservoir with recommended oil.
2. If oiler adjustment is needed, adjust the oil
regulating plug (B), clockwise to reduce flow
and counter clockwise to increase flow.

Operation

WARNING Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
Learn how the machine is switched off in the event
►
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.

Start and stop

Start the machine by slowly turning the start and
stop device clockwise, while firmly holding the
pneumatic concrete vibrator.
If the pneumatic concrete vibrator does not start
when turning the start and stop device clockwise,
try jarring the nose of the pneumatic concrete
vibrator on the ground to alter blade position.
9800 0618 90 | Original instructions
Safety and operating instructions
Stop the machine by turning the start and stop
device anticlockwise, while firmly holding the
pneumatic concrete vibrator.

Operating

Stand in a stable position with your feet well away
♦
from machine.
The start and stop device has a variable speed
♦
transmission.
Never submerge the pneumatic concrete vibrator
♦
exhaust in concrete or allow concrete, water, or
foreign material to enter the exhaust of the
pneumatic concrete vibrator.
Pour the concrete evenly into the form work in
♦
12-20 in. (30-50 cm) thick layers. Never use the
pneumatic concrete vibrator to spread the
concrete.
Vibrate the concrete systematically. Make 12-20
♦
in. (30-50 cm) vertical insertions at intervals of
8-10 times the shell diameter.
The concrete has been thoroughly vibrated, when
♦
the surface around the pneumatic concrete
vibrator is shiny and no large air bubbles rise to
the surface of the concrete. This normally takes
10-20 seconds at each location of the pneumatic
concrete vibrator.
♦ Withdraw the pneumatic concrete vibrator slowly
so that the concrete can flow into the void left by
the pneumatic concrete vibrator.
Check regularly that the machine is well
♦
lubricated.
NOTICE Never use the pneumatic concrete
vibrator to vibrate concrete buckets or similar steel
where there is solid metal to metal contact.
NOTICE Never use the pneumatic concrete
vibrator to open gates of concrete buckets.
NOTICE Never risk damage to the shell, by striking
it with a hammer or other objects.
13