Operation - Joovy First Trike Manual De Instrucciones

• Pull up on the seat to ensure it is securely attached.
Basket Assembly
• Unfasten and remove the nut, washer and bolt from the frame bar just behind the push handle
tube. (17)
• Orient the basket as shown and place it over the push handle tube. (18)
• Squeeze the spring clips and then push the basket down on this tube past these clips. (19)
• Insert the bolt down through the hole in the basket and then all the way through the hole in the
tube. (20)
• Attach the washer and then the nut to the bolt and tighten the nut using the larger end of the open
end wrench. (21)
Note: It may be easier to do this if you turn the product on its side.
• Pull up on the basket to ensure it is securely attached.
Do not load the basket with more than 4.4 lbs. (2 kg). Excessive weight may
Push Handle Assembly
• Orient the top and bottom sections of the push handle as shown. (22)
• Squeeze the spring clips and insert the top section into the bottom section until it clicks into place
and the spring clips pop through the holes. (23)
• Orient the push handle as shown onto the push handle tube of the frame. (24)
• Squeeze the spring clips on the push handle and lower it onto the push handle tube until it clicks
into place and the spring clips pop through the holes. (25)
• Pull up the push handle to ensure it is securely attached.

Operation

Securing a Child in the Seat
• Press the button on the center buckle of the harness assembly to release the waist straps and
crotch strap. (26)
• Place your child on the seat and position their legs through both waist straps and crotch strap.
• Reinsert both waist strap connectors into the center buckle. (27)
• The waist straps may be adjusted using the sliding plastic rings. Make sure the waist straps fit
snugly around the child.
Unlocking the Front Wheel Pedals
• To unlock the front wheel pedals, turn the switch on the side of the front wheel CLOCKWISE until a
click is heard. (28)
• Check to ensure that the front wheel does not rotate when pedals are rotated.
Locking the Front Wheel Pedals
• To lock the front wheel pedals, turn the switch on the side of the front wheel COUNTERCLOCKWISE
until a click is heard. (29)
• Check to ensure the pedals rotate the front wheel.
Removing the Push Handle
• Squeeze the spring clips on the push handle tube and pull the push handle upwards off of the
tube. (30)
SAVE THE PUSH HANDLE FOR FUTURE USE.
I WARNING:
cause a hazardous or unstable condition.
5