Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction:
PA-STMON40/PA-STMON60/PA-STMON80:
This active studio monitor set has a perfect response with a very natural and transparent
sound image. These speakers are bi-amplified and have an integrated electronic cross-
over for a better Signal to Noise Ratio and lower Total Harmonic and Intermodulation
Distortion. These magnetic shielded monitors are professionally designed and equipped
with an Aramid Kevlar woofer and a 1" ferro-fluid silk dome tweeter. The round shaped
corners and bass-reflex ports ensure a better sound projection.
PA-STSUB100:
This active studio subwoofer has a perfect bass response and is a good addition to the
König PA-STMON series. The speaker has a variable low-pass filter and phase switch, so
integration with your system will be no problem at all. This magnetic shielded subwoofer
is professionally designed and equipped with a high excursion Aramid Kevlar woofer. The
round shaped corners and bass-reflex port ensure a better sound projection.
Important information before use:
•
Do not place this product on an unstable cart, stand, tripod, bracket or anything else.
The product may fall, causing serious damage to the product. Any mounting of the
product should be done according to the manufacturer's instructions.
•
Make sure the heat sink's ventilation slots and openings in the cabinet are not
obstructed to ensure a continuous airflow. This enables reliable operation of the product
and protects it from overheating.
•
Be sure the required voltage for the amplifier complies with the local voltage of the main
circuit.
•
These speakers are easily capable of generating sound pressure levels (SPL) sufficient
to cause permanent hearing damage. Caution should be taken to avoid prolonged
exposure to SPL in excess of 85 dB.
Level controls:
•
With the volume control it's possible to adjust the input sensitivity, turn left for decreasing
the input sensitivity and turn right for increasing the input sensitivity.
•
Use the treble control for high frequency adjustment, turn left for decreasing high
frequencies and turn right for increasing high frequencies.
•
Use the bass control for low frequency adjustment, turn left for decreasing low
frequencies and turn right for increasing low frequencies.
•
Use the phase switch on the PA-STSUB100 for a 180º phase shift when the subwoofer
is out of phase with your main system. The phase difference determines whether they
reinforce or weaken each other. Complete cancellation is possible for waves with equal
amplitudes.
ENGLISH
2
Publicidad
