Conceptronic C300GBRS4 Manual Del Usuario página 36

ENGLISH
1. Power OFF and Power ON the device.
2. Reconnect the LAN Cable to the device and to your computer.
3. Renew the IP address of your computer with the following commands:
- "IPCONFIG /RELEASE" to release the wrong IP address.
- "IPCONFIG /RENEW" to receive a new IP address from the device.
If above steps do not solve the IP address problem, you can reset the device to the factory default settings
with the Reset Button on the back of the device.
Press and hold the Reset Button for +/- 15 seconds to load the Factory Default Settings. When the Status
LED is active again, repeat step B to renew your IP address.
Note: If the problem remains, check if all cables are correctly connected. The WAN port should be
connected to the Modem and the LAN port to the computer. Connecting them in the wrong way
will also result in not getting a correct IP address.
36
3
3