Elta 3510 Manual De Instrucciones página 8

POWER SUPPLY
This unit is designed to operate on an alternating current (AC) 230V-50Hz mains supply. The 9V battery is used for
clock back-up only in case of power failure.
RADIO OPERATION
1. To turn the radio on, slide "FUNCTION SELECTOR" (13) in "ON" position.
2. Slide Band Selector (11) in "FM" or "AM" position.
3. Adjust Volume Control (12) to desired volume level.
4. Turn "TUNING CONTROL" (9) to the frequency of the desired station.
5. To turn the radio off, slide Function Selector (13) in "OFF" position.
SETTING THE CLOCK
1. To set the hours hold down "TIME SET" (3) and press "HOUR SET" (5) simultaneously until the desired hour
is displayed. Release both buttons.
2. To set the minutes hold down "TIME SET" (3) and press "MINUTES SET" (6) simultaneously until the correct
time is displayed. Release both buttons.
WAKE UP TO RADIO OR BUZZER
1. Select desired radio station and volume level.
2. Hold down "ALARM SET/OFF" (2) and press "HOUR SET" (5) simultaneously to set the desired alarm hour.
Hold down "ALARM SET/OFF" (2) and press "MINUTE SET" (6) simultaneously for the desired setting.
3. Slide "FUNCTION SELECTOR" (13) in "AUTO" position. The radio will turn on to wake you up at the preset time.
4. To wake to buzzer instead of radio, slide "FUNCTION SELECTOR" (13) in "BEEP" position; the buzzer will turn
on to wake you up at the preset time.
5. To turn radio or buzzer off, slide Function Selector (13) in "OFF" position or press "ALARM SET/OFF" (2).
SNOOZE BUTTON
1. When the buzzer sounds or the radio turns on, pressing the "SNOOZE" button (7) will turn off buzzer or radio
temporarily. Approximately 9 minutes later buzzer or radio will turn on again.
This operation cycle can be repeated up to five times within an hour, afterwards the wake-up function will
automatically be cancelled.
2. To cancel the snooze operation, slide "FUNCTION SELECTOR" (13) in "OFF" position or press "ALARM
SET/OFF"(2).
8.