Initial Use - Princess 535599 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
Do not use the appliance if the mains cable
or mains plug is damaged or defective. If
the mains cable or mains plug is damaged
or defective, it must be replaced by the
manufacturer or an authorised repair agent.
Safety instructions for hair clippers
Before use, make sure that the hair is fully
dry.
Before use, make sure that the clipping
head and the comb attachments are free
of hair and dirt.
If you use the appliance on your own hair,
use one or more mirrors to enhance visibility.
If you use the appliance on the hair of
another person, make sure that the person
is seated at eye level.
Do not immerse the appliance in water or
other liquids. If the appliance is immersed
in water or other liquids, do not remove the
appliance with your hands. If the appliance
is immersed in water or other liquids, do not
use the appliance again.
Always protect the charging adapter from
water or excessive humidity. Do not
immerse the charging adapter in water or
other liquids. If the charging adapter is
immersed in water or other liquids, do not
remove the charging adapter with your
hands. If the charging adapter is immersed
in water or other liquids, do not use the
charging adapter again.
Description (fig. A)
Your 535599 Princess hair clipper has been
designed for clipping hair.
1. On/off switch
2. Switch for cutting/thinning hair
3. Adjustment wheel for hair length
4. Clipping head
5. Handgrip
6. Charging indicator
7. Charging station
8. Charging adapter
9. Comb attachment (cutting hair)
10. Comb attachment (thinning hair, beards
and sideboards)
11. Cleaning brush
12. Oil

Initial use

Clean the appliance.
Refer to "Cleaning and maintenance".
Clean the accessories.
Refer to "Cleaning and maintenance".
Charge the appliance.
Refer to "Charging the appliance".
Apply a few drops of oil to the teeth of the
clipping head. Switch the appliance on and
off again to distribute the oil. Remove
excessive oil from the clipping head with
a cloth.
Assembly
Warning! Before assembly, always switch off
the appliance.
Mounting and removing the
clipping head (fig. B1 & B2)
To mount the clipping head (4), insert the
clipping head into the appliance as shown
and press the clipping head until it locks
into place (fig. B1).
To remove the clipping head (4), press the
clipping head as shown and push the
clipping head forward (fig. B2).
Mounting and removing the comb
attachments (fig. C)
The appliance is supplied with two comb
attachments. Comb attachment (9) is used for
cutting hair. Comb attachment (10) is used for
thinning hair, beards and sideboards.
To mount the comb attachment, slide the
comb attachment over the clipping head (4)
into the slots (13).
To remove the comb attachment, slide the
comb attachment away from the clipping
head (4).
Use
Charging the appliance (fig. D)
Before first use, the appliance must be fully
charged for approximately 10 hours. If the
appliance starts to operate less smoothly,
the appliance must be fully charged for
approximately 8 hours.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido