Shutting Down - Cub Cadet Pressure Washer Serie Manual Del Operador

6. Connect water source to pump inlet. See Figure 5­2.
NOTE: Water source must provide a minimum of 5 gallons
per minute at 20 PSI.
Figure 5-2
7. Connect high pressure hose to pump outlet. See Figure 5­3.
WARNING:
To reduce the possibility of
contamination always protect against backflow
when connected to a potable water system.
CC4033
Figure 5-3
8. Choose the correct nozzle for the job to be performed. See
"How To Use spray Wand" instructions in the "Controls and
Features" section.
NOTE: If applying a chemical or cleaning solution, see
"How To Apply Chemicals/Cleaning Solvents" instructions
in the "Controls and Features" section.
9. Turn water source on.
NOTICE:
Risk of property damage. Failure to do so could cause
damage to the pump.
10. Remove all air from the pump and high pressure hose by
depressing trigger until a steady stream of water is present.
11. Start engine. Refer to the Engine Operator's manual packed
with your pressure washer for instructions.
CC3400
CC3600
WARNING:
Risk of unsafe operation. If engine
does not start after two pulls, squeeze trigger of gun
to relieve pump pressure. Pull starter cord slowly
until resistance is felt. Then pull cord rapidly to avoid
kickback and prevent hand or arm injury.
NOTE: If the oil level in the engine is low, the engine will not
start. If the engine does not start, check the oil level and add oil
as needed.
12. Depress trigger on gun to start water flow.
WARNING: Risk of unsafe operation. Stand on a
stable surface and grip gun/spray wand firmly
with both hands. Expect the gun to kick
when triggered.
13. Release trigger to stop water flow.
Risk of injury from spray. Always engage the
trigger lock when gun is not in use. See
Figure 5-4. Failure to do so could cause
accidental spraying.
Figure 5-4

Shutting Down

1. After each use, if you have applied chemicals, place
detergent siphon hose into container of clean water and
draw clean water through chemical injection system to
rinse system thoroughly.
NOTICE: Risk of property damage. Failure to do so could cause
damage to the pump.
2. Turn engine off. Refer to the Engine Operator's manual
packed with your pressure washer for instructions.
NOTICE: Risk of property damage. NEVER turn the water off with
the engine running.
3. Turn water source off.
4. Pull trigger on spray gun to relieve any water pressure in
hose or spray gun.
NOTE: Failure to release system pressure will prevent removal of
high pressure hose from spray gun or pump connection.
5. See Service section in this manual for proper
storage procedures.
S 5 — o
ection peration
15