Resetting The Unit - Logitech AV Stand Manual De Instrucciones

Resetting the Unit

If the unit is subject to a power surge,
it is possible that the internal micro-
controller may lock up and the unit will
not respond to any commands from
the front panel controls or remote
control. In this event, you can do one
of the following:
1. Detach the DC plug of the AC adaptor
from the unit and then reconnect after
about 10 seconds.
2. Use a straightened paper clip, toothpick
or similar objects to press the Reset
button which is located at the bottom
of the back side of the iPad dock.
Warning: Do not use sharp, pointed object
to press the Reset button. It can damage
the tact switch inside the unit.
Logitech® AV Stand
English 9