Uline H-17 Instrucciones

H-17, H-587
DELUXE LABEL
DISPENSER
1. Remove the first few labels on the roll and feed liner
under the first bar. (See Figure 1)
NOTE: Use the larger plastic roller when label core
is larger than 2" and use the smaller aluminum
roller when label core is smaller than 2".
Figure 1
Bar
2. Insert the liner between the plastic plate and coil.
(See Figure 2)
Figure 2
Plastic Plate
Coil
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTRUCTIONS
3. Pull on liner until label is released. (See Figure 3)
Figure 3
4. To use dividers, push pointed end into a slot on
Figure 4
Pour le français, consulter la page 3.
the plastic plate and affix rounded end into the
corresponding groove on the larger plastic roller.
(See Figure 4)
Para Español, vea página 2.
0421 IH-17