Craftsman 31016 Manual De Usuario página 3

removiNG DraWers
• Empty the drawer.
• Fully extend the drawer.
Lever style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops). Pull out to remove.
tab style - Depress the release tabs on both sides,
(this allows the slides to ride over the stops).
Pull out to remove.
Release
3
friction style - Fully extend the drawer. Insert screwdriver
into the slot in the side and push in on the stop until it
clears the lance. Pull drawer just past lance before
releasing stop. Repeat the process for the other slide.
iNstaLLiNG DraWers
Ball bearing slide - Pull slides and slide carrier out to fully
extended position (see illustration.) Hold the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and reclose to ensure proper operation.
slide carrier
slide