Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MANUAL DE INSTRUCCIONES
J
.P. SELECTA s.a.u.
CODIGO 80180 REV A
INSTALLATION
Room temperature is decisive when we have to measure newtonian
liquids viscosity. So it is highly advisable to install the equipment into
a room where the temperature could be controlled to get that it does
not differ more than 10ºC of test temperature.
Place controller and viscosimeter support on an horizontal surface.
Connect both elements by the supplied wire. Plug it to the mains.
Be sure that the voltage supply is the same as the one indicated
on the characteristics plate.
Do not use the equipment if it is not earthed.
If you have to change the plug cap be in mind the following:
OPERATION
CONTROL PANEL:
1. Main switch with green indicator lamp.
2. "Set" key
3. "Increase value" key
4. "Reduce value" key
5. Display
1
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.grupo-selecta.com
Blue cable: Neutral.
Brown cable: Phase.
Yellow/green cable: Earth.
07/2021
5
2 3
4
Tel 34 937 700 877 Fax 34 937 702 362
Page: 12
Publicidad
Tabla de contenido
