Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
To avoid injury or property damage,
WARNING
do not exceed maximum drawer
capacity. Use care when moving the station on
incline or rough surface. Station may tip if weight
is not evenly distributed front to back and side
to side. Place more than half the total load weight
on the bottom drawers when possible.
Locking and Unlocking the Station
NOTE: The drawers must be fully closed before
locking/unlocking the unit.
Insert the key. Turn it fully left to lock, or fully right
to unlock. Always remove the key after locking and
unlocking.
Using the Caster Brakes
To lock the swivel casters,
step down on the levers
marked ON. Be sure to lock
all casters to prevent station
from rolling or swiveling. To
unlock casters, push down
on the levers marked OFF.
Moving the Station on an Incline or
Rough Surface
Take care that the station does not tip or become
unbalanced when moving it on an incline or rough
surface. Do not exceed an incline of 10 degrees.
Lock the station and secure all items before moving.
Rolling the Station
The station is only intended for rolling short distances.
Only roll the station using the handle. Do not push or
pull station by the frame or product may tip. Do not
modify the station in any way. Drilling holes or modi-
fying the station will lower the load capacity, which
can cause the station to collapse, resulting in injury.
Lock the station and secure all items before rolling.
Lifting the Station
The station is not intended to be lifted. However, if
you need to lift, empty the station and then place
straps or forks inside and next to casters. Do not lift
loaded stations. Never lift by the side handle. Be sure
all bystanders are moved away before lifting station.
Mounting Chargers
The station comes equipped with four pre-installed
charger mounting bosses, located below the power
strip. The charger mounts are suitable for holding
MILWAUKEE M18™ & M12™ Multi Voltage chargers
as well as M18™ chargers. To mount a charger,
install a screw (CC) into each boss, then slide the
charger's key-hole slots over the screws. Slide the
charger toward the floor to lock it onto the screws.
Removing the Drawers
1. Fully extend and empty the drawer.
2. Depending on the side, either lift or lower the
release lever on both sides so the slides can ride
over the stops. Pull out to remove.
Installing the Drawers
1. Pull the slides and slide carrier out until fully ex-
tended.
2. Hold the slide on the cabinet while aligning it with
the slide on the drawer.
3. Slightly insert one side and repeat for the other
side.
4. Slowly push the drawer until it is fully closed to
engage the slide.
5. Open and close the drawer to verify proper op-
eration.
MAINTENANCE
To reduce the risk of injury, contact
WARNING
MILWAUKEE Corporate After Sales
Service Technical Support for ALL repairs and
replacement parts.
Maintaining the Station
Keep your station in good repair by adopting a regu-
lar maintenance program. Before use, examine the
general condition of your station. Check for loose
screws, misalignment, binding of wheels, broken
parts and any other condition that may affect its safe
operation. Do not use a damaged station.
Maintaining the Casters
Grease the casters annually using high quality bear-
ing grease.
6
Release Lever
Grease
Points
Publicidad
Tabla de contenido
