Care And Cleaning - Team International TEAM DAI 6 Manual De Instrucciones

Fax +32 2 359 95 50
Caution: Set the temperature dial within the steam range ('
setting is too low, water may drip from the soleplate.
Check the garment label before ironing because some cloths may be damaged when
exposed to steam or water.
SPRAY
• Produces a mist for removing stubborn creases.
• Spray can be used at any temperature setting and during either dry or steam pressing.
Press down the spray button to spray.
BURST OF STEAM
The burst of steam feature
This button also allows you to iron delicate articles of clothing vertically. This feature is called
"vertical burst of steam". To do so, hang your article of clothing on a hanger, keep the steam
button pressed and pass the iron to and fro in front of the article of clothing, making sure that
the soleplate does not come into contact with the article of clothing. The distance between
the soleplate and the article of clothing depends on the kind of textile and the creases.
DESCALING
To descale your appliance, use products made especially for this purpose that you will find in
shops and follow their instruction manual carefully.

CARE AND CLEANING

• Always unplug the appliance and let it cool down before cleaning.
• To clean the plastic parts of the iron, use a damp cloth.
• To clean the soleplate, make sure you use a product made especially for this purpose.
Never use abrasive products.
WHEN YOU HAVE FINISHED IRONING
• Turn the temperature dial to "MIN" and the steam dial to "0" and unplug the iron from the
electrical outlet.
• With the soleplate facing away from you, turn the iron upside down to empty the water.
• Then store the hot iron on its heel rest so that any remaining moisture will evaporate.
SELF CLEANING
It is important to apply "self-cleaning" at least every two months to remove impurities, etc.
The harder the water, the more the iron should be self-cleaned.
1. Open the fill opening and fill the water tank up to the MAX level, then gently close
the fill opening.
2. Set the temperature dial to MAX.
3. Insert the mains plug into the wall socket.
4. Put the iron heel up until the temperature indicator light goes out.
5. Unplug the appliance, hold it horizontally over a sink, then push the self-clean button.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
provides additional steam for removing stubborn creases.
10
Assembly page 10/44
' or ' '). If the temperature
TEAM DAI 6 - 091127