Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Fax +32 2 359 95 50
•
Turn the variable steam dial between
for a larger amount of steam.
•
Set the iron on its heel and wait until the temperature indicator goes out.
Caution: Set the temperature dial within the steam range ('
setting is too low, water may drip from the soleplate.
Check the garment label before ironing because some cloths may be damaged when
exposed to steam or water.
SPRAY
•
Produces a mist for removing stubborn creases.
•
Spray
can be used at any temperature setting and during either dry or steam p
Press down the spray button to spray.
DESCALING
To descale your appliance, use products made especially for this purpose that you will find in
shops and follow their instruction manual carefully.
CARE AND CLEANING
•
Always unplug the appliance and let it cool down before cleaning.
•
To clean the plastic parts of the iron, use a damp cloth.
•
To clean the soleplate, make sure you use a product made especially for this purpose.
Never use abrasive products.
WHEN YOU HAVE FINISHED IRONING
•
Turn the temperature dial to "MIN" and the steam dial to
the electrical outlet.
•
With the soleplate facing away from you, turn the iron upside down to empty the water.
•
Then store the hot iron on its heel rest so that any remaining moisture will evaporate.
SELF CLEANING
It is important to apply "self-cleaning" at least every two months to remove impurities, etc.
The harder the water, the more the iron should be self-cleaned.
1.
Open the filling opening and fill the water tank up to the MAX level, then gently close
the filling opening.
2.
Set the temperature dial to MAX.
3.
Insert the mains plug into the wall socket.
4.
Put the iron heel up until the temperature indicator light goes out. Then set the
temperature dial to position MIN.
5.
Hold the appliance horizontally over a sink, then remove the steam control knob
enabling the iron to self clean.
6.
Boiling water, steam and impurities will be ejected from the holes in the sole plate.
Move the iron forwards and backwards while doing so, so that every hole of the sole
plate is cleaned.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
and
for minimum steam or on the position
10
Assembly page 10/44
' or '
'). If the temperature
ressing.
and unplug the iron from
TEAM DAI 9 - 100210
Publicidad
Tabla de contenido
