Lower Control Panel; Typical Operation - Upright MB20N Manual Del Usuario

L
OWER
I
TEMS
1
2
3
4
5 Rotate Select Button
6
Table 2: Chassis Controls and Indicators
C
ONTROL
N
AMES
Enable Button
Rocker Switch
Mast Select Button
Jib Select Button
Emergency Stop
1. Enable button
2. Rocker switch
3. Mast selection button
4. Jib selection button
5. Rotate selection button
6. Emergency Stop
T O
YPICAL PERATION
Raising the mast.
• The Keyswitch located on the Upper Control box must be turned on.
• Select Mast by pressing the Mast button (3)
• Press and hold the enable button (1),
• Activate the Rocker Switch (2) in the direction required.
4 O
PERATION OF THE
P
ANEL
This button enables the Rocker Switch, and must be
held down during operation
Activates the pre-selected operation, in either direction
Pre-selects the Mast function.
Pre-selects the Jib function.
Per-selects the Mast Rotate function.
Push this red button at any time to isolate power.
Turn clockwise to reset.
P C
LATFORM ONTROLS
F
UNCTION
Figure 7: Lower Control Panel
1
2
3
4
5
6
Page 9