After Use & Storage; After Use Each Day; Hour Meter; Long -Term Storage - Upright MB20N Manual Del Usuario

6. A U
FTER SE
A
1. Ensure that the platform (masts and jib) are fully lowered.
2. Park the machine on firm and level ground, never on a grass surface.
3. Turn the key switch to the OFF position and remove.
4. Put the batteries on charge.
H
1. Climb into the basket (with the machine powered up)
2. Push the platform emergency stop button.
3. Hold down the following buttons, Horn and Lift.
4. While holding the buttons twist the emergency stop button to return power to the
5. "hr." will now be displayed on the read-out, Pressing the right turn button will scroll
L
1. Clean and touch up damaged paint surfaces.
2. Fill the hydraulic tank to operating level with the platform fully lowered. Fluid should be
3. Coat exposed portions of cylinder rods with a preservative such as multipurpose
4. Coat all exposed un-painted metal surfaces with a light oil or other preservative.
5. Cover the machine with tarpaulin if possible. If this is not available it is advisable to
& S
TORAGE
U E
FTER SE ACH
M
OUR ETER
To access the hour meter function perform the following steps.
machine.
through the accumulated hours two digits at a time. For example, if pressing the right
turn button once displays "20", pressing it a 2nd time displays "58", and pressing it a
3rd time displays "hr.", the elapsed time of operation is 2058 hours.
-T S
ONG ERM TORAGE
P
RESERVATION
visible on the tank dip stick.
grease and wrap with barrier material.
cover the mast and jib mount area as a minimum. This will prevent moisture from
entering the mast, battery and chassis areas.
D
AY
6 A U & S
FTER SE TORAGE
Figure 14: Battery Disconnect
Battery disconnect
is located behind the
controller
Page 17