Eiko ASL-3C-40K-U Instrucciones De Instalación

SAFETY PRECATION:
Read instruction carefully before attempting to install fixture. Retain instruction for future reference. Before starting the
installation and servicing, disconnect the power by turning off the circuit breaker. Turning the power off by using the light
switch is not sufficient to prevent electrical shock. All work should be done by a qualified electrician. This fixture is for
outdoor use and should not be used in areas with limited ventilation or high ambient temperatures. This product must be
installed in accordance with the applicable installation codes and ordinances by a person familiar with the construction
and operation of the product and the hazards involved.
NOTE: In order to comply with established electrical code, the installer must seal the area around the mounting plate and
the wall, with silicone sealant to provide a watertight seal.
WIRING:
LED units are 120V~277V. No additional tap wires are provided.
NOTE: Check voltage is compatible with fixture light engine.
1. Connect the black fixture lead to the hot.
2. Connect the white fixture lead to the neutral.
3. Connect the green fixture lead to the ground.
TROUBLE SHOOTING CHECKLIST: If the luminaire does not work.
Check your power source.
Type III (asymmetric, type 3)
EiKO Global, LLC • 23220 W. 84th St, Shawnee, KS 66227 • (P) 1-800-852-2217 • (F) 1-800-492-8975 • eiko.com
EiKO Canada • 81 King St, Barrie, Ontario L4N 6B5 • (P) 1-705-721-5189 • (F) 1-705-721-7855 • orderdesk@eiko.com
Rev. 4/11/16
INSTALLATION INSTRUCTIONS
ASL-3C-40K-U | ASL-3C-50K-U
ASL-5C-40K-U | ASL-5C-50K-U
LED Performance Area Light
Check electrical connections.
Type V (symmetric, type 5 )