Preparing The Base Unit For Use; Powering The Base Unit; Power Supply - Sempre 92596 Manual Del Usuario

USA

Preparing the base unit for use

− When installing on a wall, ensure that no electric
cables, gas or water pipes are buried beneath the
wall surface before drilling any holes.
− The maximum distance between the base unit and
radio sensor should not be greater than 100 m (direct
visible distance). Building materials, such as concrete
walls, may reduce or prevent signal reception
between the base unit and radio sensor.
− Do not place the base unit and radio sensor on the
floor. This limits the transmission range.
− Electronic devices such as televisions and computers
can disrupt the signal reception.
− At low temperature during winter, the performance
of the radio sensor batteries may fall significantly.
This reduces the transmission range.
1. Mount the hanging bracket
hanging or screw hole (nail or screw not provided).
2. Attach the radio sensor
(see Fig. C).
Preparing the base unit for use

Powering the base unit

Power supply

The base unit can be powered by batteries
or an alternating current (AC) power supply
using the power adaptor.
20
1 855 754 8297
USA
26
to the hanging bracket
17
Aldi-US@Supra-elektronik.com
on a wall using the