Asus WL-330gE Manual Del Usuario página 6

Disable your PC's proxy settings when using web configuration. Make sure
the WL-330gE and your PC are under the same subnet. Check the contents
of the Internet protocol (TCP/IP) settings of your local area connection
2. Specify an SSID (Service Set Identifier), which is a unique identifier attached
to packets sent over WLAN.
3. Select a security level to enable encryption methods:
Low(None): No security level.
Medium (WEP-64bits)
Medium (WEP-128 bits)
High (WPA-PSK/WPA-PSK)
4. Choose "Enable" Hotspot Mode if you would like to wirelessly connect to
the hot spot.
5. Click Finish to save the configuration.
After setting the ASUS WL-330gE in Router/Gateway mode, you need to
connect the WL-330gE's LAN port to an ADSL modem through an RJ45 cable.
You can only set up your local network wirelessly such as through Windows
Zero Configuration or your wireless card utility on your PC.
You can set up the advanced functions. Click the Advance Settings link to
go to the Advance Settings screen.
ASUS WL-330gE Portable Wireless Access Point
WL-330gE_QSG(E).indd 5
®

7/9/07 4:39:17 PM