Displays; Connecting Your Babycom 268; Inserting The Batteries (Parental And Baby Unit); Information On Using The Batteries - Swissvoice Babycom 268 Manual De Instrucciones

Displays

Out-of-range alarm symbol
Baby asleep symbol: no signal / standby mode
Battery status symbol
Fully charged
Low: You need to charge the batteries
Discharged (flashing display): You need to charge the
batteries immediately
Baby calling symbol: continually alternating display

Connecting your Babycom 268

Inserting the batteries (parental and baby unit)

- The unit must be switched off. Press the
key on the belt clip and rotate it 90 degrees
to the right or left.
- Open the battery compartment.
- Insert the AAA batteries supplied (making
sure the poles are correct).
- Close the battery compartment.

Information on using the batteries

Use only the original batteries (3 x NiMH, AAA, 1.2 V 600 mAh) and the
original mains adapter (7.5 V DC, 600 mA) for your Babycom 268.
Babycom 268
49