Setting The Sensitivity (Baby Unit Only) - Swissvoice Babycom 268 Manual De Instrucciones

Babycom 268
Scanning the Parental unit:
corresponding
code
automatically
Baby unit:
Corresponding
Baby unit and parental unit:
code was
scanned
successfully
Normal status
Code scanning Parental unit:
failed
Baby unit:
Note:
- There is no need to set CTCSS code before using the Babycom 268
for the first time: As soon as you switch the parental and baby units
on, they automatically search for a shared code.
- If you are using the adapters for power, connect them first, and then
switch the units on before changing the CTCSS code.

Setting the sensitivity (baby unit only)

Set the preferred sensitivity level by sliding the black switch
battery compartment of the baby unit:
- Up: (HI) = high sensitivity (responds to noises within a range of 2-6
meters)
- Down: (LO) = medium sensitivity (responds to noises within a range of
1-2 meters).
54
Flashing
Flashing
or
still
flashing
still
flashing
Constantly changing
on the