KRESS 1050 FME-1 Manual Original página 17

40974_BA_FME_1603.book Seite 17 Mittwoch, 2. März 2016 5:51 17
Safety rules
Secure the workpiece.
A workpiece clamped with clamping
devices or in a vice is held more
secure than by hand.
The rated speed of cutting tools must be at least
equal to the maximum speed marked on the power
tool.
Cutting discs or other cutting tools running with
overspeed can fly apart and cause injuries.
Do not use blunt or damaged router bits.
Blunt or damaged router bits cause increased fric-
tion, can become jammed and lead to imbalance.
Apply the machine to the workpiece only when
switched on.
Otherwise there is danger of kickback when the
cutting tool jams in the workpiece.
Never cut over metal objects, nails or screws.
The router bit can become damaged and lead to
increased vibrations.
Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
Take protective measures if there is danger of for-
mation of combustible or explosive dust during
operation that can be hazardous to health.
Example: Some dusts can be carcinogenic. Wear
a dust mask and work with a dust/chip extraction
unit, if possible to connect.
Always wait until the machine has come to a com-
plete stop before placing it down.
The tool insert can jam and lead to loss of control
over the power tool.
During operation, always ensure that the mains
and extension cable is to the rear away from the
device.
This prevents anyone from tripping over the cable
while working.
Do not carry the machine by the cable.
Move the switch to the "OFF" position before
removing the plug from the plug socket.
When the tool is reconnected to the mains acci-
dental starting of the machine is avoided, thus
reducing the risk of accidents.
Tools not in use must be locked away
safely in a dry place out of the reach
of children.
To mark the machine, do not drill into
the housing.
The protective insulation would be
bridged. Use stickers.
Never use the machine with a dam-
aged cable. Do not touch the damaged
cable and pull the mains plug when the
cable gets damaged during operation.
Damaged cables increase the risk of
electric shock.
Residual risk. Although this information sheet and
the operating manuals for our electrical tools contain
extensive instructions on safe working with electrical
tools, every electrical tool involves certain residual
risks that cannot be completely prevented through
safety mechanisms. Therefore, electrical tools must
always be operated with the necessary caution.
English 17
EN
FME-EN / 1603