Tools And Accessories; Changing The Collet - KRESS 1050 FME-1 Manual Original

40974_BA_FME_1603.book Seite 22 Mittwoch, 2. März 2016 5:51 17
22 English

5. Tools and accessories

Always wear a dust protection mask when
EN
working with the power tool.
Do not attach a saw chain woodcarv-
ing blade or toothed saw blade.
Such blades create frequent kickback
and loss of control over the power
tool.
Permissible grinding tools
You can use all grinding tools shown in the illus-
trated instructions.
Observe the permissible speed and circumferen-
tial speed specified on the label of the grinding
tool.
The ratings on the type plate of the power tool
must not exceed the permissible speed [rpm] and
circumferential speed [m/s] of the grinding tools
used.
For safety reasons, the grinding tools must not be
operated at circumferential speeds exceeding 80
m/s.
When using grinding tools, always observe
the information provided by the grinding tool
manufacturer.

Changing the collet

Release the tightening nut 1 and remove the tool
using suitable cut protection (Caution - Danger of
injury).
Standard collet
FME-EN / 1603
Unscrew the tightening
nut 1 with the collet 2.
Using your thumb and
index finger, press the col-
let 2 together at the con-
tinuous slot.
Tilt the collet 2 off and
remove it from the tighten-
ing nut 1.
Tools and accessories
Collet ER16
Unscrew the tightening
nut 1 with the collet 2.
Tilt the collet 2 first
towards the marker on
the tightening nut 1 and
then out to the side.
Caution! To protect the thread,
screw the tightening nut 1 lightly onto
the spindle 3, but never tighten it if no
tool is inserted. The collet 2 could be
pressed together too tightly and dam-
aged.
Working with a flexible shaft
Due to its adjustable speed, the milling and grind-
ing motor is also ideal for use as a drive motor for
flexible shafts.
When using the motor for this purpose, it is impor-
tant to ensure that the motor does not exceed the
maximum permissible speed for the flexible shaft.
Wear protective glasses and hearing
protection.