Descargar Imprimir esta página

Philips HR 4347/00 Manual De Instrucciones página 9

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
- Place the filter upside down
onto the new container of
carbon granules and snap
the corners onto each other
(fig. 47).
48
50
- Turn the container with the filter on top of it around with both
hands (fig. 48). Shake the granules into the filter and make
sure they are distributed evenly (fig. 49).
- Remove the plastic container and put a new foam pad onto
the active carbon (fig. 50)
- Close the top of the filter again (fig. 51).
- Repeat this procedure for the second carbon filter.
- New carbon granules are available from your retailer under
number HR 4941.
Resetting the active carbon replacement indicator
52
After you have replaced the active carbon, the replacement
indicator must be reset:
- Switch the air cleaner on (fig. 52).
- Press the reset control (P) for at least 3 seconds (fig. 53).
The pilot light comes on or keeps burning for 3 seconds and
then goes out to show that the indicator has been reset.
47
49
yy
51
yy yy
yy
yy
yy
yy yy
yy
yy
53
3 sec.
Automatic cut-out to prevent overheating
To prevent damage to the appliance due to overheating and to
limit the risks, the automatic cut-out ensures that the motor is
switched off when it becomes too hot.
To indicate that the appliance is still switched on and
connected to the mains, the pilot light of the on/off control will
continue to burn.
If this happens:
- Switch the air cleaner off.
- Unplug the air cleaner.
- Allow the appliance to cool down (approx. 15 minutes).
- Remove the front of the appliance. Make sure that the filters
are not covered or blocked and that the airflow is not
obstructed.
- Check if the fan is able to
rotate freely by turning it with
your hand (fig. 54).
- Close the appliance. Put the
plug in the wall socket and
switch the appliance back
on.
If the automatic cut-out is
activated repeatedly, we advise
you to take your appliance to
your dealer for a technical
inspection.
Specifications/technical data
Power consumption
(highest setting)
CADR (highest setting)
- tobacco smoke
- dust
- pollen
Filter system:
- Prefilter
- HEPA filter
- Active carbon filters
HEPA replacement filters
Active carbon
replacement set
Maximum size of room
9
54
60 Watt
3
89 m
/hour
3
91 m
/hour
3
93 m
/hour
1
1
2
HR 4940
HR 4941
2
3
40m
/100m

Publicidad

loading

Este manual también es adecuado para:

Hr4347/70