Tripp-Lite B127F-1A1-MM-DD Manual De Propietario página 7

Standard Extender Kit Installation
Make sure all equipment in the installation is powered OFF.
1
Using a DisplayPort cable (such as Tripp Lite P580-XXX DisplayPort
2
cables), connect the DisplayPort source to the INPUT port on the local
transmitter unit.
(Optional) Using an HDMI 2.0 cable (such as Tripp Lite
3
P569-XXX-CERT or P568-XXX-2A Series cables), connect a local
monitor to the LOCAL port on the local transmitter unit. The LOCAL
(orange) LED will illuminate to indicate the port is connected to a
display.
B127F-1A1-MM-DD – Using duplex LC multimode (850 nm) fiber
4
cable (such as Tripp Lite N520-XXM Series cable), connect the LC
fiber port on the local transmitter unit to the LC fiber port on the
remote receiver unit.
B127F-1A1-SM-DD – Using duplex LC singlemode (1310 nm) fiber
cable (such as Tripp Lite N370-XXM Series cable), connect the LC
fiber port on the local transmitter unit to the LC fiber port on the
remote receiver unit.
Using a DisplayPort cable (such as Tripp Lite P580-XXX Series cables),
5
connect the remote receiver unit's DisplayPort to a monitor.
Turn on the power to all of your connected displays (local and remote).
6
Connect the external power supply to the local transmitter unit and
7
plug it into an available wall outlet or (optional) a Tripp Lite Surge
Protector, Power Distribution Unit (PDU) or Uninterruptible Power
Supply (UPS). The POWER (green) LED on the local transmitter unit
will illuminate to indicate the unit is receiving power from the external
power supply. The POWER (green) LED on the remote receiver unit will
illuminate to indicate the units are receiving power from the external
power supply.
-03-232-933976.indb 7
7
4/15/2019 4:42:42 PM