Package Contents - DeWalt DE7400 Manual Del Usuario

EN GLI SH
• DO NOT use the stand on uneven
surfaces. DO NOT use the stand with
the legs folded and stand sitting on
the ground. The stand is designed to
be used on a flat, stable surface.

Package Contents

The package contains:
1 Stand
2 Carriage head bolts
2 Mounting brackets
4 M8 lock nuts
2 Wheels
1 Rear axle
2 Rubber bumpers
2 M4 screws
4 Washers
2 M4 lock nuts
1 Kickstand assembly
2 Tube plugs
M6 screws (4)
M4 hex wrench
Saw mounting hardware:
4 hex head bolts
8 washers
4 nuts
4 lock washers
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1A, 1B)
WARNING: Never modify the accessory
or any part of it. Damage or personal
injury could result.
NOTE: Figure 1B shows the front of the DE7400.
a. Axle
b. Leg supports
c. Wheels
d. Saw mounting bracket
e. Bracket release levers
f. Leg release levers
g. Locking pins
16
h. Legs
i. Beams
j. Locator clip
k. Handle
l. Handle lock
m. Rubber bumpers
n. Kickstand
o. Tube plugs
INTENDED USE
This rolling table saw stand is designed for use with
D WALT DW744 and DW745 table saws only. If
E
you have any problem with alignment or mounting,
consult an authorised D WALT repair agent.
E
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
ASSEMBLY
Attaching the Wheels and Axle
(fi g. 1, 2)
1. Attach the axle (a) to the leg support (b) by
aligning the pre-drilled holes. Ensure the long
end of the axle is to the rear of the stand as
shown. Secure axle to leg support using two
carriage bolts, washers and lock nuts provided.
2. Place the wheels (c) on the axle and secure with
washers and lock nuts as shown. Tighten wheel
and axle nuts securely.
Attaching the Kickstand (fi g. 3–5)
Insert the tube plugs (o) into the end of the kickstand
(n). The groove in the tube plug should be facing
down as shown. Be sure that the holes (p) in
the tube plugs are in line with the holes (q) in the
kickstand tube before inserting the tube plugs.
Insert the kickstand (n) through the holes in the leg
support (b) on the wheel-axle side of the stand. Be
sure the kickstand is pointing up when the stand
is an upright position. Secure the kickstand to the
beams (i) with the four M6 screws provided.
The hex wrench may be stored in the end of the
tube plug as shown for future use.