Norstar CTA 150i Guia De Instalacion página 14

12 Norstar TAPI SP installation
Port
For an external interface device, select the serial port to which the
device is connected on your PC.
Base Address
Select the address that matches the switch settings on your card or
port.
IRQ
Select an available hardware interrupt number for your computer. For
the CTA 150i card, valid values are in the range from 2 to 7, and 9.
7. Click OK when you have finished setting the properties for your
interface device.
A message appears, warning that changes will only take effect when
you restart Windows.
8. Click OK to confirm.
9. When the Installation Complete dialog appears, you can click either
View README to see the README.TXT file, or Return to
Windows to exit the setup program.
10. Restart Windows.
You may now install, configure, and run the TAPI application(s).
Configuring Norstar TAPI SP
Note: There is generally no need to configure the Norstar TAPI SP after
installation, since it is done as part of the installation procedure.
Typically, post-installation configuration is only required should an
interface device need to be moved to a different serial port on the PC.
To configure the Norstar TAPI SP:
1. Locate the Control Panel icon as follows:
(Windows 3.1) Double-click the Main program group in the Program
Manager.
The Main group displays.
(Windows 95) Double-click the My Computer icon.
The My Computer group displays.
Computer Telephony Adapter 150 Installation Guide