Brita SHS-102 Instrucciones De Instalación

Proper Installation
Remove Existing Shower Head
Step 1
• Remove existing shower head from shower arm.
• Clean shower arm to remove any residue
or debris.
Apply Plumber's Tape
Step 2
• Wrap plumber's tape clockwise around the
threads on the end of shower arm.
Install Filter System
Step 3
• Screw Filter System onto the threads of shower
arm in a clockwise position until hand-tight.
• Using wrench, tighten an additional 1/4 turn.
!
CAUTION
Do not over tighten, as this may result in damage to the Filter System.
Flush System
Step 4
• Turn on water to shower head. In order for the
Filter System to flush out any air and carbon
fines (fine black powder) from the Filter
Cartridge, allow the water to run for
approximately 1 minute.
SHS-102 Installation Instructions
SHS-102_IM_V1-0B.indd 1
Tools & Materials Required
SHS-102
Installation
Instructions
SHS-102 Installation Instructions
materials and tools needed
adjustable
wrench
CAUTION
1
2
3
4
Version 1.0B SHS-102 Installation Instructions
main components secondary
components
filter system
tools needed for
installation
filter cartridge
866.709.2086 Internet & Mobile
Manufactured for: Protect Plus, LLC 420 3rd Avenue NW, Hickory, NC 28601 USA
© 2014 Protect Plus. All rights reserved. Protect Plus is a trademark of Protect
Plus, LLC. The BRITA trademark and logo are registered trademarks of Brita LP
and are used under license by Protect Plus, LLC. All rights reserved.
Filter Replacement
(every 6 months)
For FREE Filter Replacement Reminder, go to
www.protectplus.com
Note: Water may drip from the Filter System during cartridge removal.
• Turn off water to the Filter System.
• Turn head of Filter System counter-clockwise until it releases. Gently
remove housing and pull out used Filter Cartridge and discard.
• Insert a new Filter Cartridge.
• Screw the head of the Filter System clockwise back onto the housing
until tight.
• Turn on water to shower head. In order for the Filter System to flush out
any air and carbon fines (fine black powder) from the Filter Cartridge,
allow the water to run for approximately 1 minute.
package contents
main:
filter system
filter cartridge
plumber's tape
secondary:
plumber's tape
adjustable
wrench
Free Installation Video
Version 1.0B
Version 1.0B
6/6/2014 10:33:18 AM