Robertshaw E Serie Instalación

WArNINg:
ELEcTrIcAL ShOck hAzArD.
Turn off power at the main power source before installing a
clothes Washer Water Valve. DO NOT restore electrical power
to the unit until the clothes Washer Water Valve is properly
installed and the compartment cover is secured with the
retaining screws supplied with the unit.
1. Disconnect the power source to the unit.
2. Turn off the water supply.
3. Remove inlet hoses from the water valve. Place both
hose ends into a bucket to catch any water drainage.
4. Pull the appliance away from the wall being
careful not to put a kink in the water line.
5. Remove the compartment cover to gain access to the
water valve. Keep any retaining screws.
6. Disconnect the wiring plugs from the water valve coil.
Identify which plug connects to hot and which plug
connects to the cold side of the valve.
7. Remove any screws retaining the water lines and the
valve. Keep the retaining screws.
8. Disconnect the hose on the outlet of the water valve.
9. Connect the outlet hose to the outlet of the new water valve.
10. Put the new water valve into the original valve location and
secure it with the retaining screws.
11. Connect the wiring plugs to the water valve coil. Make sure
the correct plug is connected for the hot and cold sides.
12. Re-attach the compartment cover and secure the cover with
the retaining screws.
13. Reconnect the inlet hoses to the water valve. Make sure the
correct plug is connected for the hot and cold sides.
14. Push the appliance back against the wall being
careful not to put a kink in the water line.
15. Reconnect the electrical power.
16. Turn the water supply on and check for leaks.
191 E. North Avenue
Carol Stream Illinois 60188 USA
Customer Service Telephone 1.800.304.6563
Customer Service Facsimile 1.800.426.0804
HVACCustomerService@Invensys.com
CLOTHES WaSHEr WaTEr VaLVES
For Technical Service
Telephone 1.800.445.8299
Facsimile 1.630.260.7294
TechnicalService@Invensys.com
INSTALLATION DATA
E SEriES and n-51 SEriES
Uni-Line and Robertshaw are trademarks of Robertshaw
® ®
Controls Co. its subsidiaries and/or affiliated companies.
All other brands mentioned may be the trademarks of
their respective owners.
E-1
E-2
E-2T
N-51
www.Uni-Line.com
www.InvensysControls.com
©2014 Robertshaw Controls Co.
03/14 – 352-00178