Description Of Functions; Power Off; Important Usage Notes; Use And Functions - therm-ic Snowlife POWERPACK MAX+ Manual Del Usuario

I NSTRUCTI ONS FOR USE / ENGLI SH
DESCRI PTION OF FUNCTIONS
The Max+ Powerpacks have two operating modes:
POWER OFF - IN USE
These modes are clearly indicated on the status
display (red LED).
POWER OFF: The level switch is set to level "0".
The status display (red LED)
remains off. The Powerpack is now
completely switched off.
IN USE: The Powerpack is supplying the
connected Therm-ic sole with
power. Each Powerpack can be
individually set to one of three
different heat levels. The status
display (red LED) turns on.
I M PO R T A NT USA G E NO T ES
When using the heating element cable, plug it into
the Powerpack until it can be clearly felt to
engage.
If the maximum charging duration (13 hours) is
overshot, this does not damage the Powerpacks.
10
However, frequent overcharging can reduce the
efficiency and service life.
Always connect both Powerpacks to the Therm-ic
standard charger at the same time.
When starting up, do not allow level 3 to be
switched on longer than a few minutes in each
case. Otherwise, too much heat can be produced
during operation, which could lead to burns.
Always set Powerpacks to level 1 or 2 to maintain
a comfortable level of warmth for your feet
(heating should be almost undetectable).
The optimum heat output is reached when your
shoes and soles are dry.
USE AND FUNCTI ONS
The desired heat level can be individually set for
each Powerpack using the level switch (levels 1, 2,
3).