Identification Code; Compatibility - Sony Ericsson MMV-100 Manual Del Usuario

MMV-100-UG-R1A-EN-DE-ES-FR-IT-NL.book Page 5 Friday, April 16, 2004 12:30 PM
To connect the MMV-100 to a
digital projector
1
Connect the CST-13 to the MMV-100 and to a
power supply. The CST-13 must be connected
at all times.
2
Connect the MMV-100 to the digital projector
using the RCA cable (only the yellow plug
for image).
3
A start-up picture is displayed.
Depending on the type of TV set or digital projector,
RCA connections vary. When only mono sound is
supported, use the yellow plug and either the red or
the white plug. When no sound is supported, use the
yellow plug only.

Identification code

An identification code, consisting of MMV 100
and a unique four-digit/letter code, is shown at the
bottom of the screen (for example MMV 100
A4BZ). The identification code is used when the
phone searches for Bluetooth devices and a list of
available devices is displayed.
To be able to view your identification code, you
must unplug and then plug in the CST-13 again.

Compatibility

There are a few general requirements to ensure the
optimal performance of your MMV-100.
Introduction
5