Swann SwannBuddy Guia De Inicio Rapido página 8

The SwannBuddy can be mounted on the surface using the supplied mounting bracket as shown below.
Before mounting the SwannBuddy, ensure the desired installation location has good, reliable Wi-Fi
reception. Using the app, try streaming live video from the SwannBuddy there. If you don't experience
any video streaming issues, you've found a good place for your device. You can expand the Wi-Fi
coverage of your current network by installing a Wi-Fi range extender.
Ideal installation height
Around chest-height, 1.6-1.7m
(5.2-5.6ft) from the ground.
Attaching the SwannBuddy
Align the mounting bracket slots on
the back of the SwannBuddy with the
mounted bracket, and then slide it
down. Tighten the anti-tamper screw
with a small Philips screwdriver to
®
secure in place.
EN
8
MOUNT THE SWANNBUDDY
Anti-tamper
screw hole
Installing the bracket
• If mounting on a wooden surface, screw
the bracket directly to the surface.
• If mounting on a masonry surface
or drywall, insert wall plugs before
screwing the bracket to the surface.
• If mounting on a window panel, use the
supplied double-sided (rectangular)
tape. Peel off liner on one side of the
tape and apply it to the back of the
bracket. Peel off opposite liner then
using a firm amount of pressure, press
the bracket against the window panel
for 60 seconds. Allow 24 hours for the
adhesive to fully cure before attaching
the SwannBuddy onto the bracket.
Anti-tamper screw
• (Screw-installation only) If there is a
gap between the wall and bracket, use
the supplied bracket foam tape to fill it.