Safety Instructions; Technical Data - AL-KO K26 Manual Del Usuario

en
INSTALLATION
For drawbar:
Type K26
Bolting the drawbar to the axle and clamp
connection
Drawbar connection profile (a)
Fit the drawbar with two M16 hexagon
bolts.
Drawbar connection profile (b)
Fit the drawbar with an M16 hexagon bolt.
Bolting the drawbar to the trestle and
clamping bracket
Attach the clamping bracket to the frame (front
edge of the assembly) using two M12 bolts.
CAUTION!
Observe the length ratio (L1 : L 2 < 2,5)!

SAFETY INSTRUCTIONS

CAUTION!
The tightening torques must be checked after 100 km and retightened to the prescribed values
if necessary!

TECHNICAL DATA

Type
Drawbar, rectangular hollow section
Recommended bolts
Tightening torque
4
L
L
L L
K26
100 x 100 mm
M12 - 8.8
M16 x 130 - 8.8
M12 - 75 Nm
M16 -195 Nm
a
b
1311932_a