2.
Lift the bottle safely (see assembly above) and place
bottle until it's secure and bottle is seated.
Plug the cord into a properly grounded wall outlet. WARNING: Always
3.
make sure that the cord is away from a water source.
Dispensing Cold Water
After setup, it will take up to 6 hours to get the water to its maximum cold
temperature. When it reaches max temperature, the green light will turn off.
1.
Place bottle, glass, or pitcher below the cold water tap.
2.
Press the cold water button downward
to start dispensing water.
3.
Release the button once the desired fill
level is achieved.
Dispensing Hot Water
After setup, it will not take long to reach maximum
hottest temperature. When it reaches hottest
temperature, the red light will turn off. NOTE: For
safety, there is a lock on the dispensing button.
1.
Place bottle, glass, pitcher, pot below the hot water tap.
2.
Release child-safety lock by sliding the red button
and press the hot water button downward at
the same time to start dispensing water.
3.
Release the button once desired fill level is achieved.
NOTE: Be careful when dispensing hot water as temperature can reach 203 °F.
Replacing An Empty Bottle
Replace the bottle as soon as you notice that it is empty.
1.
Lift the bottle straight up to disengage it from the bottle probe.
2.
Remove the tamper seal from the bottle cap of the NEW
bottle. DO NOT remove the plastic cap.
3.
Lift the bottle and insert it (assembly directions above). Apply slight pressure
until the plug inside the cap pushes in and the bottle is secure.
HELPFUL TIPS
DISPENSER IS NOT WORKING
•
Make sure that the power cord is properly connected to a working outlet.
WATER IS LEAKING
•
Replace water bottle. Most common cause is a cracked bottle.
NO WATER IS COMING OUT
•
Make sure bottle is not empty. If so, replace it.
•
Make sure that you fully press the water control buttons.
WATER DISPENSER IS NOT COLD
•
Make sure cold switch is ON. Switch is located in the back of the water cooler.
7