Reset The Dynamic Ip-Windows 2000 - Kyocera KR1 Manual De Instrucciones

Hold the
2. RESET
The
Note: POWER LED
indicating proper connections.
Connect the LAN cable to one of the four LAN ports. The LED of the LAN port
3.
you select will illuminate green.
Launch your web browser. An error message may appear. Disregard this
4.
message, and continue with the steps below.
Enter
5. 192.168.0.1
A screen similar to the following will appear.
Select
6. Browse
firmware version. Select your desired firmware version, and click
Click , to send the latest firmware to your Kyocera KR1 Mobile Router.
7. Send
Please do not click any buttons once the firmware download process has
Caution:
started. Doing so could disrupt the firmware download process, and cause your
Kyocera KR1 Mobile Router to malfunction.
Your Kyocera KR1 Mobile Router and computer may not provide an accurate
Note:
indication of activity. An error screen may appear. This is normal. Please be patient.
The firmware recovery process will take five to ten minutes. The firmware recovery is
complete when the WLAN LED blinks green.
Reset the Dynamic IP–Windows 2000
Right click
1. My Network Places
Select
2. Properties
Right click on
3.
Select
4. Properties
Select
5. Internet Protocol (TCP/IP)
Click
6. Properties
button for 10 seconds, and then release it.
will illuminate green, and the
in the address line of your web browser, and press
. A dialogue box will appear prompting you to select the latest
.
.
Local Area Connection
.
.
STATUS LED
.
.
8
will blink green,
.
GO
Open.