Luna 26202-0209 Manual Del Usuario página 12

• Do not wear loose long hair, loose clothing or jewellery, which could become caught up in
moving parts of the tool and cause injuries and clothing damages.
• A switched-on tool may be directed towards the work material only. Loose parts may disunite
and cause damages. A person or an object may become in contact with the tool, which could
cause an accident or material loses.
• Cold or wet hands, smoking and snivel may increase vibration caused hazards.
• Let the tool operate and by holding the handle use the least possible force. If possible, the tool
should be supported on a stable support block.
• Interruption of work should be ensured or another kind of work, not involving use of vibra-
ting tools should be alternatively performed, in order to reduce the harmful influence caused
by the vibration.o Ensure that the workplace is well lit.
Important information
Tools must be lubricated
Before use always lubricate the tool with a few drops of oil AIRTOIL 22 (Luna 15531-0105)
intended for use with pneumatic tools by dropping it into the air inlet opening of the tool. In
case of continuous work, a pneumatic lubrication system (Luna 20571-0106) should be used,
adjusted to about two drops per minute.
If the tool is not used for a longer period of time, it is required to drop a few drops of oil before
storage of the tool, in order to reduce the corrosion risk.
Attention! Use only oil that is supposed for pneumatic tools specified in the operation instruc-
tions. Use of other oils may result in "clumping" of oil and reduction of the movement ability
of the machine. It may cause reduced work efficiency.
Leakages must be avoided
Avoid leakages in the air circulation system. Always use a thread sealing tape at the point where
the pipe is connected to the tool. Pay attention that hoses and hose fastening clamps are in good
working order.
The compressed air must be dry
As clean and dry the compressed air is, the longer is lifetime of the tool. In order to ensure that,
we recommend use of air filter, which removes water from the compressed air and reduce risk
of damages on tool and connections caused by corrosion.
Remember to remove eventual water condensate from the compressor and the compressed air
supply system before each working day.
Remember!
24
Instructions
• Under no circumstances should a defective machine or sockets/accessories be used as this
may cause injury and material loss.
• The plastic plug should be taken out of the air inlet opening (Pos.4) and an insertable hose
connection with 1/4" external thread should be used.
• During fitting or removal of impact sockets and accessories, the machine must always be
disconnected from the compressed air supply. It will help to ensure that the machine does not
accidentally start when changing sockets/accessories.
• Before starting the machine ensure that any impact sockets or accessories are correctly
secured on the square drive (Pos.1). Only good quality impact sockets and accessories should
be used with this machine, the use of sockets and accessories designed for hand operation is
dangerous. After fitting of the socket or accessory the machine must not be operated in idle
running directed away from the working material. The socket/accessory may come loose
from the machine which may cause injury or material loss.
• Check air pressure and, if necessary, adjust it so that the machine can operate at the required
pressure and torque. Adjustment of the pressure is performed by use of the compressor or
separately installed pressure regulator and adjustment of the torque is performed by use of
a separate air supply regulator (not included). Specification of the machine complies with a
6.2 bar pressure.
• Always adjust the air outlet ring (Pos.2) so the cold air and loose particles avoid hitting the
body.
• Always be careful when using the machine. Misuse and abuse of the machine may cause
damage to the internal parts and housing. It may result in a reduction of efficiency and the
machine may loose its value.
Check-out: Lubricating is important in oder to reduce noise and vibration level. In case of
continuous use of the tool is should be cleaned and checked at least 2 times a yea.
25