Ferm LMM1012 Traducción Del Manual Original página 12

Assembling the grass box
Fig. A, I, J, K
It is possible to use the lawn mower with or
without grass box. Remember though that when
cutting without the grass box, the grass box lid
(11) must be lowered. Do not operate the mower
with outlet lid lifted.
1. Join the two halves of the grass box basket
(10), as shown on figure I.
2. Mount the grass box cover (12) onto the
assembled grass box basket (10), as shown on
figure J.
3. Lift the grass box lid (11) and attach the
assembled grass box onto the lawn mower.
Ensure the indents in the grass box align
properly with the holders of the lawn mower
body.
Note: the grass box is fitted with a grass level
indicator (13), which shows the amount of mowed
grass. As long as the grass box is not full, the
indicator will be opened. When the grass box
is full, the indicator will close. In that case
immediately stop mowing and empty the grass
box. This indicator is only a rough guideline, of
which the functionality depends on the condition
inside the grass basket.
Replacing the cutting blade
Fig. A, P
Before carrying out any work on the
machine, disconnect the mains plug
from the power supply
When replacing the cutting blade, wear
protective gloves. Danger of injury when
touching the cutting blade.
Only use blades that are recommended
by the manufacturer.
1. Remove the grass box.
2. Turn the mower onto its side.
3. Firmly hold cutting blade using protective
gloves.
4. Turn the cutting blade fixing screw counter-
clockwise to loosen it, as shown on figure P.
5. Replace or sharpen the cutting blade.
12
6. Install the cutting blade, use the above
procedure in reversed order (holes in the
cutting blade must be seated on the spindle
pins).
7. It is best to entrust sharpening or replacement
of cutting blade to a qualified person. Only
original parts should be used.
All defects should be repaired by service
workshop authorized by the manufacturer.
4. OPERATION
Before using, always visually inspect to
see that the blades, blade bolts and
cutter assembly are not worn or
damaged. Please keep power switched
off and disconnect the power supply.
Replace worn or damaged blades and
bolts in sets to preserve balance.
Adjusting the cutting height
Fig. A, L, M
Switch off the equipment, disconnect
the plug and wait for the blade to stop.
There is a risk of injury.
Depending on the preferred cutting height, you
can adjust the wheel assembly in one of three
positions.
1. Put the lawn mower on its side.
2. Grasp the wheel axle on both sides.
3. Pull evenly on the axle and insert into one
of the three notches, as shown on figure L.
Ensure the left and right side of the axle are
mounted in the same notch. Repeat this step
for both axles. Ensure the front and rear axle
are mounted in the same notch, so the lawn
mower cuts parallel to the lawn.
4. Each notch position resembles a cutting
height, as shown on figure M.
Position 1 resembles a cutting height of 25 mm.
Position 2 resembles a cutting height of 40 mm.
Position 3 resembles a cutting height of 55 mm.
Note: A higher cut height should be selected for
the first cut of the season.