Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4 Keeping your shaver in top shape
4.1 Cleaning
•
After shaving, switch the shaver off. Press the release buttons, take off the
shaving frame (d) and gently tap it out on a flat surface (e).
•
Then thoroughly clean the cutter block with the brush (f). About every four
weeks, clean the cutter block with Braun cleaning agents (g).
•
Do not clean the shaving foil with the brush.
•
If you have a very dry skin and you notice a reduced operation time of the
shaver, you should put a drop of sewing machine oil onto the cutting parts
of the shaving frame (g).
4.2 Changing the shaving parts
•
To maintain optimum shaving performance, we recommend to replace the
shaving frame and the cutter block every 1
worn. (Shaving frame and cutter block: part no. 3600)
•
Press the release buttons, take off the shaving frame. Replace the new
shaving frame in the right direction until it locks in place.
•
To remove the cutter block, lift it off (g).
To replace the cutter block, snap onto the holding studs.
4.3 Preserving the cell unit
•
In order to maintain the capacity of the cell unit, the shaver has to be
discharged approximately every 6 months. Then recharge to full capacity
again.
•
Do not expose the shaver to temperatures of more than 122 °F / 50 °C for long
periods of time.
5 Environmental notice
This appliance is provided with a nickel-hydride cell unit.
This cell does not contain any harmful heavy metals. Nevertheless,
in the interest of recycling raw materials, please do not dispose of
this appliance in the household waste at the end of its useful life.
Disposal can take place at a Braun Service Center or appropriate
collection sites.
Subject to change without notice.
1
/
years or when these parts are
2
7
Publicidad
Tabla de contenido
