Bionaire BDH001X Manual De Instrucciones página 5

INSTRUCTIONS
Description (Fig. 1)
1. Control Panel
2. Air Intake Cover
3. Water Tank
4. Drainage Port (on rear)
Control Panel (Fig. 2)
A. Humidity Control Button
B. Power Button
C. Power Light
D. Water Tank Full Light
E. Defrost Light
F. Humidity Setting Lights
OPERATING INSTRUCTIONS
Plug unit into an appropriate electrical outlet.
Press the Power Button to begin operation.
Press the Humidity Control Button to set the required
humidity level. Repeatedly pressing the Humidity
Control Button cycles through the level settings.
HUMIDITY SETTING
The humidity setting sets the level of humidity.
Example: Setting the unit to "60%" will cause it to
automatically switch on when the air's humidity level
reaches 60% or higher, and to automatically switch
off when the desired level has been reached.
WATER TANK FULL
When the Water Tank Full light is on, the
dehumidifier will automatically switch off.
Remove the Water Tank from the front of the
dehumidifier and empty it. Re-insert the empty Water
Tank to resume operation.
AUTOMATIC DEFROST
When defrosting of the compressor is required, the
dehumidifier will automatically switch off and begin
its defrosting cycle. The Defrost Light will illuminate.
The dehumidifier will resume operation once
defrosting is complete.
DRAINAGE HOSE
Inserting the supplied drainage hose into the
Drainage Port on the back of the dehumidifier will
redirect collected water, allowing for continuous
drainage without the need to manually empty the
Water Tank. Place the open end of the drainage
hose into a suitable receptacle or drain to remove
the outgoing water from the dehumidifier.
NOTE: The drainage hose must be lower than the
drainage port for proper operation. Small amounts
of water may still collect in the tank even when
continuous drainage is in use.
INTAKE COVER
Lifting the Intake Cover allows more air to flow into
the dehumidifier, increasing its efficiency. The level
of air intake is adjusted by angling the Intake Cover
to increase or reduce how quickly the dehumidifier
reaches its humidity setting.
CLEANING AND MAINTENANCE
1. Turn the unit off and unplug it from the electrical
outlet.
2. Remove, empty and rinse the Water Tank with
warm water.
3. Use a soft clean cloth to wipe the unit. Do not
use gasoline, paint thinner or other cleaning
products to clean the unit.
4. To clean the filter, carefully remove if from the
back of the dehumidifier and clean it with a
vacuum cleaner or rinse with cool water. Allow to
dry thoroughly before replacing.
STORAGE INSTRUCTIONS
When the dehumidifier is not in use:
1. Turn the dehumidifier off and unplug it from the
electrical outlet.
2. Clean and dry the dehumidifier thoroughly as per
the cleaning instructions.
3. Make sure all parts are dry before storing. Do
not store with any water in the tank.
4. Store upright in a cool, dry location.
5