Features - Surtek CN506 Manual De Usuario

bracelets and other jewelry.
• Wear ear protection, goggles and a dust pro-
tection mask.
• To protect long hair, wear a cap or hair net.
• For changing the planer/jointer knives, wear
solid gloves.
• Do not wear any gloves for working on the
machine, with the exception when handling
rough work pieces.
• The safety mechanisms on the machine may
not be removed or rendered unusable. Clean-
ing, changing, calibrating, and setting of the
machine may only be carried out when the mo-
tor is switched off. Pull the power supply plug
and wait for the rotating tool to completely
stop.
• Use a dust extractor unit for eliminating
wood chips or sawdust . The air flow rate at
the suction connector must be 20 m/s.
• Do not use any planer/jointer blades showing
cracks or having changed their shape.
• Only use well sharpened planing knives.
Blunt blades increase the risk of backlash.
• Always match the planer/jointer block pro-
tector to the work piece width. The unused
part of the knife block must be covered.
• Use a feed stick for short work pieces.
• Only use well sharpened planing knives.
Blunt blades increase the risk of backlash.
• Always match the planer/jointer block pro-
tector to the work piece width. The unused
part of the knife block must be covered.
• Use a feed stick for short work pieces.
PROPER USE
• The planer/jointer with its tools and accesso-
ries offered has exclusively been designed for
the treatment of wood.
• When working with the standard equipment,
the work pieces must not exceed the table size.
Passage width 204 mm, passage height 120
mm.
• Larger work pieces that could tilt from the
table top, require the use of a table length ex-
tension or a roller stand (optional equipment).
• When used in enclosed rooms, the machine
must be connected to a dust extractor unit to
remove wood chips and sawdust. The air flow
rate at the suction connector must be 20 m/s.
• Never switch off or remove dust extractor
units with the main machine running.
12
• The machine may only be used with original
accessories and original tools of the manufac-
turer.
ATTENTION: The use of other tools or acces-
sories than stated in the operating instructions,
can hold the risk of injuries.
• Any other use exceeds authorization. The
manufacturer is not responsible for any dam-
ages resulting from unauthorized use; risk is
the sole responsibility of the operator.
• The rotating planing spindle can cause inju-
ries to fingers and hands if the work piece is
incorrectly fed.
• Thrown work pieces can lead to injury if the
work piece is not properly secured or fed, such
as working without a limit stop.
• Wood chips and sawdust can be health haz-
ards. Be sure to wear personal protective gear
such as safety goggles and a dust mask. Use a
vacuum exhaust system.
• Injuries through defective planer/jointer
blades. Check the blades regularly for their
perfect condition.
• Risk of injuries to finger and hands when
changing the planer/jointer blades. Wear suit-
able gloves.
• Risk of injuries through the starting planer/
jointer blades when switching on the machine.

FEATURES

KNOW YOUR TOOL
Before attempting to use this planer/jointer,
become familiar with all of its operating fea-
tures and safety requirements.
WARNING: Do not allow familiarity with
the machine to cause carelessness. Remember
that a fraction of a second of carelessness is
enough to inflict severe injury.
4
3
1
2